The applying technique with Koh-I-Noor sticker is the perfect match between quality, innovation and simplicity in the bathroom accessories attachment.
This system, celebrating its 10th birthday, ensures an excellent grip and high performances.
Clean the wall/surface with a solution of water and alcohol (50%).
Measure precisely using a level to check the linearity of the surface, marking the exact points you will apply the accessory.
Break the tube and apply a light coat of the primer on the wall, to increase its adhesive power, then let it dry for 5 minutes.
Remove the protective film, being careful not to touch the sticky part and so decreasing its adhesive strength.
Apply the accessory to the wall, starting with the upper side, following precisely the marks before indicated.
Push very strongly for a few seconds on the accessory. To allow a perfect drying, do not load it for 24 hours at least.
ADVANTAGES OF THE STICKY SYSTEM
Check if the surfaces are leveled before applying the accessories.
They can be positioned on all leveled, shiny, opaque, rough surfaces (max. roughness 0,5 mm) except for unrefined walls and plasters.
Cleaning products containing silicon might damage applying. If the positioning takes place at less than 15°C, we suggest to warm the surface using a hairdryer. Possible primer surpluses can be removed with a rag soaked of alcohol.
To clean: use only neutral PH products and warm water. Do not use aggressive products or powders.
Accessories can be removed levering using a spatula towards the outside. The glue left can be removed using a spatula and/or a rag soaked with acetone and trichloroethylene.